Solution: Please use SADPTool software to search the DVR/NVR and change its resolution on the computer. Solution: If possible, please use another monitor/display/TV to have a try.Ĭause 4: The resolution of DVR/NVR is higher than the monitor/display/TV Also, please use another HDMI/VGA cable to have a try.Ĭause 3: The monitor/display/TV may have some problem or it is not compatible with DVR/NVR If you use a VGA connection, please try the HDMI connection. Solution: If you use the HDMI port on DVR and HDMI cable to connect DVR to a monitor/display/TV, please try the VGA port on DVR and use the VGA cable. Even the power light is on, please also change the power adapter.Ĭause2: The HDMI/VGA connection may have some problem Solution: Please use another power adapter with the same voltage to have a try. You may follow the troubleshooting tips listed below to solve the problem.Ĭause 1: The DVR/NVR Power adapter is insufficient or cannot be powered normally There are several possible causes of your DVR/NVR that do not show its setting panel. ![]() Applies to: DT41Y/DT61Y/DT81Y/DN41R/DN61R/DN81R/DT41GB/DT81GB/DT61GB/DW41JD/DW81KD/DW61LD/DT81DP/N48PI/N44PI/N46PI/N44PAM/N48PAW/N46PCK/N88PCH/N441Y/N481Y/S500/S300/FC200/NCK800/H800/H500/FC800/E800Īfter you connect the DVR/NVR to a monitor/display/TV, it shows no signal or just black and blank on the monitor(Attached picture for your reference), you can do some troubleshooting to find out the problem.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |